Honeywell Galaxy Flex - Page 137

Galaxy Flex Installer Manual Communications [56]
137
ISDN Primary Format [56.3.01.4]
The ISDN module provides seven signalling formats:
1=DTMF
2=SIA
3=Microtech
4=Contact ID
5=Robofon
6=X.25 Protocol 1 (SIA based format compatible with the OA BX X.25 receiver)
7=X.25 Protocol 2 (SIA based format compatible with the Alphatronics RC 4000 receiver)
Note: The DTMF, SIA, Microtech and Contact ID formats are identical in structure and
programming to the Telecom Module menu.
Note: X.25 Protocol 1 and Protocol 2 are similar in programming structure to the SIA
protocol.
ISDN Secondary [56.3.02]
The secondary option is available to support Dual and Alternate dialling to a second
destination receiver. If using alternate mode both the dial type and format must be identical
to the values programmed for the primary number.
1=Default Telephone Number The programming is identical to Telephone Number 1
[56.1.02].
2=Default Account Number Refer to Primary [56.3.01.2].
3=Dial Type Refer to Primary Dial Type (except X.25 should be
option not available).
4=Format Refer to Primary Format. It is possible to assign different
formats to both the Primary and Secondary numbers,
however, when using the alternative signalling option the
format must be identical.
5=Copy Primary (1 to 2) Copies Primary Program to Secondary Program, for ease
of programming.
6=Alternate If enabled, signalling is attempted alternately to primary
and secondary numbers until successful transmission to
either is achieved. If enabled, the user will be requested
to copy the primary programming to the secondary
programming to ensure both paths are configured
identically.
ISDN Type [56.3.03]
Two types of ISDN lines are available on the EURO ISDN network; Point to Multipoint and
Point to Point.