Galaxy Flex Installer Manual Additional programming
21
Reset Levels (65 ent) – defines which user type can reset specific faults
Confirm (55 ent) – controls how confirmed alarms are generated
Keypad Access (54 ent) – disable unset on entry
RF Parameters (60 ent) – access these options:
RF Address (1 ent) – enable and disable wireless virtual RIO addresses
RF Fob PA (2 ent) – enable to allow users to program the Panic Alert function of
wireless keyfobs
Program zones (52 ent + Zone Address)
Function (01 ent) – assign zone function
Descriptor (02 ent) – name a zone (up to 16 characters)
Part (05 ent) – zone included in a part setting option
Omit (04 ent) – zone omitted when using an omit function
Chime (03 ent) – opened zones cause momentary chime when system unset
Group (10 ent) – assign zone to a group, if enabled
Resistance Select (09 ent) – change pre-defined resistance for the selected zone
Activity Monitor (08 ent) – check zone activity
RF Options (11 ent) – access these options:
Serial No. (1 ent) – manual or self-learn entry of wireless device serial number
Loop No. (2 ent) – loop number of multiple input wireless devices
Supervision (3 ent) – enable for periodic device supervision
Auto Reset (4 ent) – enable to force zone to automatically close after five seconds
Signal Level (5 ent) – display device signal level
Program outputs (53 ent + Output Address)
Output Function (1 ent) – assign an output type
Descriptor (5 ent) – name an output (up to 12 characters)
Output Mode (2 ent) – access these options:
Latch (1 ent) – output active unlit a valid code entered
Reflex (2 ent) – output follows activity of trigger event
Pulse (
3 ent) – output remains active for a programmed pulse time
Output Groups (7 ent) – assign groups to the output
To Next Page
Loading...
