Granit XP User Guide 95
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the barcode below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming Chart, beginning on page 291, then Save.
2D Reread Delay
Sometimes 2D barcodes can take longer to read than other barcodes. If you wish to
set a separate Reread Delay for 2D barcodes, scan one of the programming codes
that follows. 2D Reread Delay Off indicates that the time set for Reread Delay is
used for both 1D and 2D barcodes. Default = 2D Reread Delay Off.
Character Activation
You may use a character sent from the host to trigger the scanner to begin scan-
ning. When the activation character is received, the scanner continues scanning
until either the Character Activation Timeout (page 4-97) is reached, the deactiva-
tion character is received (see Deactivation Character on page 97), or a barcode is
User-Specified Reread Delay
To Next Page
Loading...
