Honeywell Granit XP 199 i Series - Application Work Group Selection; Reset the Factory Defaults: All Application Work Groups

Granit XP User Guide 67
settings for whatever work group to which that the scanner was previously
assigned. For example, if the scanner was in work group 1 linked to the first base, it
will be placed in work group 1 in the second base with the associated settings.
Application Work Group Selection
This programming selection allows you to assign a scanner to a work group by
scanning the barcode below. You may then program the settings (e.g., beeper vol-
ume, prefix/suffix, data formatter) that your application requires. Default = Group 0.
Reset the Factory Defaults: All Application Work Groups
The following barcode defaults all of the work groups to the factory default set-
tings.
* Group 0
Group 1
Group 2
Group 3
Group 4
Group 5
Group 6
Factory Default Settings:
All Work Groups
PAPDFT&