Honeywell Granit XP 199 i Series - Page 257

Granit XP User Guide 239
RS232 Handshaking *RTS/CTS Off 232CTS0 35
Flow Control, No Timeout 232CTS1 35
Two-Direction Flow Control 232CTS2 35
Flow Control with Timeout 232CTS3 35
RS232 Timeout (1-5100
milliseconds)
232DEL#### 35
*XON/XOFF Off 232XON0 36
XON/XOFF On 232XON1 36
*ACK/NAK Off 232ACK0 36
ACK/NAK On 232ACK1 36
Scanner-Bioptic Packet Mode *Packet Mode Off 232PKT0 37
Packet Mode On 232PKT2 37
Scanner-Bioptic ACK/NAK Mode *Bioptic ACK/NAK Off 232NAK0 37
Bioptic ACK/NAK On 232NAK1 37
Scanner-Bioptic ACK/NAK Timeout ACK/NAK Timeout (1-30000
milliseconds) *5100
232DLK##### 37
Cordless System Operation
Link the Scanner to the charge
base
Legacy Mode LKBMOD0 39
Compatibility Mode LKBMOD1 40
Replace a Linked Scanner Override locked Scanner (Single
Scanner)
BT_RPL1 40
Temporary Streaming Presentation
Mode
*10 Second Timeout TRGTPM10000 43
30 Second Timeout TRGTPM30000 43
Presentation Mode in Base *Disabled BT_PIB0 44
Enabled BT_PIB1 44
Connect with Bluetooth Device
directly
Disabled BT_CEN0 69
Enabled BT_CEN1 69
Base Power Communication
Indicator
*On :*:BASRED1 47
Off :*:BASRED0 47
Reset Scanner Reset Scanner RESET_ 49
Base Charge Modes Base Charge Off BTRCHG0 50
*External or Interface Cable Power BTRCHG1 50
External Power Only BTRCHG2 50
Page Mode *On BEPPGE1 50
Off BEPPGE0 50
Page Pitch *Low (1000 Hz) BEPPFQ1000 51
Medium (3250 Hz) BEPPFQ3250 51
High (4200 Hz) BEPPFQ4200 51
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page