Honeywell HR 10 F - Changing the Operating Modes; Changing to the Manual Operating Mode; Changing to the Programming Mode

Operation
17
Changing the operating modes
The Roomtronic disposes of 3 operating modes:
• Automatic mode* (AUTO)
• Manual mode* (MANU)
• Programming mode* (PROG)
The automatic mode is the standard mode of the Roomtronic.
Temperatures and heating periods are controlled by the time program.
"AUTO" is displayed.
Changing to the manual operating mode
Changes to the setpoint temperature can be carried out at the
adjusting ring of the operating unit in manual mode. The time program
is not active.
► Press the button at the operating unit.
"MANU" is displayed.
Changing to the programming mode
You can adjust the time program to your own requirements in
programming mode. For further information please refer to Chapter
"Adapting" from Page 20 onwards.
► Press the button at the operating unit.
"PROG" is displayed.