Performance Series HQA Digital Video Recorder Local User Guide
96
Table 8-1
Configuration Description
Enable Click to enable alarms. Select a channel from the drop-down list.
Alarm Name Enter an alarm name.
Period
Define a period during which motion detection is active.
1. Click Set. The Set configuration interface appears.
2. Click Set after a day of the week to set time periods for that day.
3. Enter a time range (Period) for when the event detection area is active,
then click the check box to activate that Period.
Note You can configure up to 6 periods within one day..
4. Click Save.
To Copy Time Periods to Other Days
1. Click Set to select a day with configured time periods.
2. Click the boxes besides the days to select the days to which to copy
the periods.
3. Click Save.
Show Message
Click to enable a pop-up message on your local host PC screen to let you know an
alarm has occurred.
Send Email
The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system can also send an image
attached to the email. Go to Main Menu
Setting
Network
Email to configure
the email settings. See
Configuring Email Settings on page 78.
Record Channel
The system automatically starts recording selected channels when a motion
detection alarm occurs.
Note You need to set the alarm recording period.
Go to Storage
Schedule to configure the current channel for scheduled
recording. See
Configuring Record Settings on page 111.
PTZ Activation
When PTZ activation is configured, the system can activate.
1. Click Set to open the PTZ Activation configuration interface.
To Next Page
Loading...
