Performance Series HQA Digital Video Recorder Local User Guide
154
A Installing Hard Drives
The appendix contains the following sections:
• Installing a Hard Drive, page 154
• List of Compatible SATA HDDs, page 155
• List of Compatible Portable HDDs, page 158
Installing a Hard Drive
On some HRHH DVR models, you can install an additional hard disk drive (HDD). For a list of
compatible HDDs, see the List of Compatible SATA HDDs on page 155. A 7200 rpm or higher
HDD is recommended.
CAUTION Risk of electric shock. Disconnect power before
removing cover.
To install an additional HDD
1. If the DVR is connected to a power source, disconnect it before continuing.
2. Remove the top cover from the DVR housing by removing the four screws securing it to
the housing and then sliding the cover backwards.
3. Connect the SATA and power cables to the new HDD.
4. Position the new HDD over the four open screw holes in the base of the housing, adjacent
to the existing HDD.
5. Turn over the DVR housing and secure the new
HDD to the housing using the four supplied
HDD mounting screws.
6. Attach the HDD to housing with the four screws
removed in step 4.
7. Replace the DVR top cover on the DVR housing
To Next Page
Loading...
Need help?
General