16 AMPS-24 Manual — P/N 51907:J2 02/26/2014
Installation In a BB-25 Cabinet
2.3 In a BB-25 Cabinet
The AMPS-24 mounts in the left side of a BB-25 cabinet. Two 26 amp-hour batteries fit into the
right side of the cabinet. A BB-100 or BB-200 cabinet is required for batteries larger than 26
amp-hour.
2.4 In a BB-100 Cabinet
The AMPS-24 mounts in a BB-100 cabinet. Two 55 or 100 amp-hour batteries fit into the bottom of
this cabinet under the AMPS-24. The power supply is fastened directly to the the backbox using the
two provided keps nuts.
Figure 2.3 BB-25 Cabinet Mounting
Fasten the power supply to the backbox with (2)
#8-32 self-threading screws (p/n 38132) at the
indicated positions.
amps24_bb25b.CDR
Figure 2.4 BB-100 Mounting
BB100_AMPS24_2Batta.wmf
Fasten the AMPS-24 chassis to the backbox using the two
supplied #4-40 keps nuts (p/n 36045) at these positions.
WARNING: Heavy Load!
The total weight of a fully loaded BB-100 will exceed 175 pounds. Additional support may be required
when mounting this cabinet to a wall.
See BB-100/200 Cabinet Installation Instructions for more information.
To Next Page
Loading...
