ID50 Series Panel - Installation, Commissioning & Configuration Manual
Appendix 2 - ID60 Panel Differences
A2 - 8997-263-000-11, Issue 11
January 2010
2 Using the numeric keypad enter the Access Level 3
passcode. The Sensor Maintenance screen is
displayed:
3 Press the ‘
1
’ pushbutton on the numeric keypad to
display VIEW
TM
, MULTI, Optiplex/SM2, SM3 and SM4
sensor maintenance data:
The device reference and type is given along with the date
and time the sensor entered the maintenance state. The
current maintenance state of the VIEW
TM
, MULTI, Optiplex/
SM2, SM3 and SM4 sensors are also given, i.e. Active.
The status will remain Active after the 100-day advisory
period has elapsed.
Note: Where maintenance data is listed in the log (listed
in address order) for more than one sensor, use
the ‘
2
/
8
’ buttons to review the other log entries.
Sensor Replacement
When a VIEW
TM
, MULTI, Optiplex/SM2, SM3 or SM4
sensor has been replaced, the maintenance log entry for
that device is retained but the maintenance status is
changed to ‘Inactive’ and will remain in the log until it is
manually deleted.
Deleting Maintenance Log Data
Sensor data ‘demoted’ to Inactive status can be removed
from the maintenance log; all Active status data will be
retained. To delete all inactive data:
5 Using the numeric keypad press
2
to select the
‘Clear’ option.
6 Press the ‘
5
’ button to confirm. The Maintenance
menu screen is re-displayed.
When all inactive log entries have been deleted and with
no active log entries present, the following message is
displayed:
7 Press the ‘
4
’ button to return to the View Mode
menu.
[Sn Maint] 1: Display 2: Clear
3: Service
[Sn Maint] Snn AAA dd/mm/yy mm/hh Active
< - - - - - - - - - - - - - Zone Text - -- - - - - -- - - - - - - >
* * * * No Devices in Maintenance * * * *
Clear inactive maintenance entries?
Press to Confirm <: Cancel
[Sn Maint] Snn AAA dd/mm/yy mm/hh Inactive
< - - - - - - - - - - - - - Zone Text - -- - - - - -- - - - - - - >
1
2
5
To Next Page
Loading...
