NFS2-640 Operations P/N 52743:L4 06/10/19 17
Section 3: Operation of the Control Panel
3.1 Overview
This section contains instructions for operating the control panel. Listed below are the topics
detailed in this section:
This manual also contains information on operating the control panel in the appendixes, listed as
follows:
• Appendix A, “Special Zone Operation”, on page 56
• Appendix B, “Intelligent Detector Functions”, on page 66
• Appendix C, “Remote Terminal Access”, on page 67
• Appendix D, “Point and System Troubles Lists”, on page 75
Section Refer to Page
3.2, "Normal Mode of Operation" page 18
3.3, "Fire Alarm Mode of Operation" page 18
3.4, "Mass Notification Mode of Operation" page 21
3.5, "System Trouble Mode of Operation" page 25
3.6, "Security Alarm Mode of Operation" page 27
3.7, "Active Supervisory Signal Mode of Operation" page 28
3.8, "Pre-Alarm Warning Mode of Operation" page 31
3.9, "Disabled Points Mode of Operation" page 32
3.10, "Non-Alarm Mode of Operation" page 32
3.11, "CO Alarm Mode of Operation" page 33
3.12, "Active Trouble Monitor Mode of Operation" page 35
3.12, "Active Trouble Monitor Mode of Operation" page 35
3.13, "Output Circuit Trouble Mode of Operation" page 36
3.14, "Operation of Special System Timers" page 38
3.15, "Waterflow Circuit Operation" page 40
3.16, "Class A and Class X Operation" page 40
WARNING:
WHEN USED FOR CO
2
RELEASING APPLICATIONS, OBSERVE PROPER PRECAUTIONS AS
STATED IN NFPA 12. DO NOT ENTER THE PROTECTED SPACE UNLESS PHYSICAL
LOCKOUT AND OTHER SAFETY PROCEDURES ARE FULLY COMPLETED. DO NOT USE
SOFTWARE DISABLE FUNCTIONS IN THE PANEL AS LOCKOUT.
To Next Page
Loading...
Need help?
General
