Section 6. System Programming
6–37
L1-L2
Entry
Auto-
arm
Audible Arm
Warning
Instant
Arming
Stay
Arming
0
1
✔
3
✔ ✔
5
✔ ✔
7
✔ ✔ ✔
9
✔ ✔
B
✔ ✔ ✔
D
✔ ✔ ✔
F
✔ ✔ ✔ ✔
Auto-arm: Arms the system in AWAY mode at time
specified in Programming Submode 1, Questions 29
and 30 for partitions 1 and 2, respectively.
Audible Arm Warning: If enabled, allows an audible
keypad sound to warn of auto-arming.
Instant Auto-arming: Arms the system with entry
delay disabled.
Stay Auto-arming: Arms the system in STAY mode.
NOTE: All auto-arm modes will force-arm the system. This means any open zones at the time of auto-
arming will be bypassed. To report these bypassed zones, program a bypass code in Programming
Submode 2, Question 44, L1.
U
L
Must be programmed as “0” for UL installations.
Q 28, L4 Up and About Enables
L4
Entry
Up and About
Part. 1
Up and About
Part. 2
0
1
✔
2
✔
3
✔ ✔
Up and About: If no controlled zone is violated within a 24-
hour period (beginning at midnight), a signal is sent to the
central station. This can serve as a safety feature for elderly,
infirm, or disabled persons.
QUESTIONS 29–30 AUTO-ARM TIMES
These questions set the auto-arming time for each partition.
L1/L2: Enter hour 00–23 by entering the first digit of the hour (0–2) in L1 and the second digit (0–9) of
the hour in L2. (00 = 12 midnight)
L3/L4: Enter minute 00–59 by entering the first digit of the minute (0–5) in L3 and the second digit (0–
9) of the minute in L4.
For example, to set an auto-arm time of 11:35pm, enter 2 in L1 and 3 in L2, then enter 3 in L3 and 5 in
L4.
U
L
Must be disabled for UL installations.
QUESTION 29 AUTO-ARM TIME PARTITION 1
L1 L2 L3 L4
Hours (00-23) Minutes (00-59)
QUESTION 30 AUTO-ARM TIME PARTITION 2
L1 L2 L3 L4
Hours (00-23) Minutes (00-59)
To Next Page
Loading...
Need help?
General
