PC42E-T Desktop Printer User Guide 43
DEFAULT SETTINGS
This appendix contains all of the default settings for the printer.
Default Configuration
Use this appendix to view the default settings on the printer. If you restore the
printer to factory default settings, it will use the values listed here. The order of the
settings reflects the organization of the printer web page.
Ethernet Settings
This section describes the Ethernet IPv4 settings. To view these settings:
• From the printer web page, click Configure > Communications > Ethernet.
• From PrintSet 5, click Configuration> Communications > Ethernet.
IPv4
Setting Description Default
IP Assignment
Method
Specifies how the printer obtains an IP address. DHCP
IP Address Specifies the unique network-level address that is
assigned to each device in a TCP/IP network (IPv4).
0.0.0.0
Subnet Mask Specifies a number that defines the range of IP
addresses that can be used in a TCP/IP network.
0.0.0.0
Default Router Specifies the IP address of a router that is used when a
device sends a packet to another subnet or to an
unknown destination.
0.0.0.0
DHCP Response Specifies if the printer receives DHCP responses by
broadcast or unicast.
Broadcast
To Next Page
Loading...
Need help?
General
