46 PC42E-T Desktop Printer User Guide
Media Length Sets the length of the printable area measured from one
edge of the label to the edge that is closest to the
printhead. Unit of measurement is defined in the Unit of
Measurement parameter.
Variable
Print Mode Selects the printer media mode: tear off, peel-off, cutter,
or rewind.
Tear off
Clip Default Determines if the printer prints items outside the
printable area of the label.
When this is set to Off, the printer returns an error if any
part of a barcode label cannot be printed because that
part extends beyond the printable area.
When this is set to On, the printer prints all bar ode
labels, but may also print unreadable, incomplete
labels.
Off
Label Top Adjust Sets the length of media the printer feeds (positive
value) or retracts (negative value) before printing a
label. Unit of measurement is defined in the Unit of
Measure parameter. Range is -9999 to +9999.
0 dots
Label Reset
Adjust
Sets the length of media the printer feeds (positive
value) or retracts (negative value) after printing a label.
Unit of measurement is defined in the Unit of Measure
parameter. Range is -9999 to +9999.
0 dots
Media
Calibration Mode
Selects the mode the printer uses to calibrate media.
Use Fast calibration (ECO mode) to conserve media.
The printer media calibration process will use a minimal
length of labels.
Use Slow calibration if the printer has trouble
identifying gaps or marks in media. The printer media
calibration process will use the length of multiple labels.
Slow
Length (Slow
Mode)
If Media Calibration Mode is set to Slow, the printer
prints the media length plus 10 mm. This value sets an
additional amount of media to be printed. Unit of
measurement is defined in the Unit of Measurement
parameter.
0 dots
Setting Description Default
*935-044-001*
Honeywell
9680 Old Bailes Road
Fort Mill, SC 29707
Media
length
To Next Page
Loading...
Need help?
General
