Confirmation Output mode
A channel is configured as a confirmation output and is associated with an input at another channel, but not
its own channel.
Mode settings notes
Confirmation Output Output type: See page 4.
Fail safe
See page 4.
Mains Failure See page 4.
Associated Input The selected input channel is associated with the
confirmation output channel. Note channel 1 cannot be
selected for associated input as it is already being used
as an output.
Output Normally See page 4.
Output with Zone Input mode
This is when a channel is configured as an output and the channels input terminals are Zone Input.
Mode settings notes
Output / Zone input Zone input type See page 5.
Output type See page 4.
Sync. pulse See page 4.
Failsafe See page 4.
Mains failure See page 4.
Validation delay See page 5.
Reset period See page 5.
Output normally See page 4.
Commissioning information S4 Mains powered interface unit
8 4188-968 issue 2_Part 2_09-10_S4 mains interface
www.acornfiresecurity.com
www.acornfiresecurity.com
To Next Page
Loading...
