Honeywell S4-34440-12 - Confirmation Output with Fault Input mode; Confirmation Output with Fire Input mode

Confirmation Output with Fault Input mode
This example shows how to set a confirmation output when there is a state change on the associated fault
input.
Mode settings notes
Confirmation
Output/Fault Input
Output Type: See page 4.
Failsafe See page 4.
Mains failure See page 4.
Output normally See page 4.
Associated Input See page 8.
Input Delay See page 6.
Input Normally See page 6.
Confirmation Output with Fire Input mode
This example shows how to set a confirmation output when there is a state change on the associated fire
input.
Mode settings notes
Confirmation
Output/Fault Input
Output Type: See page 4.
Failsafe See page 4.
Mains failure See page 4.
Output normally See page 4.
Associated Input See page 8.
Input Delay See page 6.
Input Normally See page 6.
Output normally See page 6.
4188-968 issue 2_Part 2_09-10_S4 mains interface 13
S4 Mains powered interface unit Commissioning information
www.acornfiresecurity.com
www.acornfiresecurity.com