Honeywell S4-34440-12 - Confirmation Output with Zone Input mode

Confirmation Output with Zone Input mode
This example shows how to set a confirmation output when there is a state change on the associated Zone
input.
Mode settings notes
Confirmation
Output/Fault Input
Zone Input Type See page 5.
Output Type: See page 4.
Failsafe See page 4.
Mains failure See page 4.
Output normally See page 4.
Associated Input See page 8.
Validation Delay See page 5.
Reset Period See page 5.
Output Normally See page 4.
4188-968 issue 2_Part 2_09-10_S4 mains interface 11
S4 Mains powered interface unit Commissioning information
www.acornfiresecurity.com
www.acornfiresecurity.com