Honeywell ScanPal EDA51

P13
5) Press down the battery cover safety button to move the battery cover safety lock to the lock position
at left.
Battery icon
Battery icon on the status bar shows the power status of the battery. The following table only contains several of
the icons. For detailed information about battery life and power remained, please go to Settings > Battery.
Battery icon
Icon
Status
Battery power is 100% full
Battery power is 50% full
Battery power is too low. Replacing the battery right now.
The terminal has been connected to external power supply for charging.
Power indicator
LED flashing red
Battery failure occurs. Please replace the battery. If the failure still exists, please contact
Honeywell technical support.