Honeywell ScanPal EDA51

P48
Imager settings
There should be no need for users to change image color rendering. Override Recommended Values is disabled
by default. Recommended image settings can be applied in many environments; only the users who have more
in-depth understanding on the image can change the settings.
Trigger settings
Trigger settings can set up the using patterns for scan key.
Settings
Description
Default
Enable Scan trigger
Enable or disable scan trigger
Enabled
Scan delay
Set the start scaning delay time
0
Decoding timeout
If the scan trigger is held down but decoding is
not successfully performed, Scanning will
automatically shut down after 20 seconds
20
Trigger Scan mode
Set the scan mode:
• One shot
• Continuous
• Read on release
• Read on second trigger press
One shot
Same Symbol timeout
If the scanner continue to scan the same code, it
will automatically shut down after the set times.
Disabled