P20
Battery maintenance recommendations and safety protection measures
• Fully charge the battery before using it. The battery is only partly charged when get packed.
• Refer to the chapter "charging" to get the right process for battery charging. Using the battery for other
devices may cause damages on the device or the battery.
• Avoid battery or terminal drops. If you suspect that a battery or terminal fails, send it to Honeywell
service center for verification.
• This battery can only replace another BAT-EDA51-X battery. These batteries have been tested and meet
the appropriate safety standards. If you need to replace the battery, please contact Honeywell service
representatives or the resellers.
• There are security risks in waste batteries. Before cleaning up the battery, stick the poles with insulation
tape.
• Do not modify the battery or attempt to insert foreign objects into the battery.
• Do not solder directly to the battery poles.
• Do not short connect the battery and put the battery away from metal objects.
• Do not drop or mechanically shock or extrude the battery.
• Do not disassemble or open the battery. Do not crush, bend or deform the battery; Do not puncture, shred
or burn the battery.
• Do not immerse the battery in water.
To Next Page
Loading...
