Honeywell ScanPal EDA51 - Page 16

P18
Changing power indicators
If the default indicators for battery charging (flashing green) are inappropriate for your environment, you can
change the indicator.
In addition to changing the default power indicator, you can also select:
• Default Battery LED
• No Battery LED
If you prefer the indicator to be solid amber and to change to solid green when in charging, you need to perform
Default Battery LED settings. If you prefer the indicator as message notification (application or device
management solution notification) indicator, you need to select No Battery LED settings.
Default power indicator meanings
Connect to power supply
Indicator status
Description
No
Flashing red
Battery power is less than 15% full
No
No light
Battery power is 15% or more
Yes
Stable red
Battery power is less than 15% full
Yes
Stable amber
Battery power is between 15% to
90% full
Yes
Stable green
Battery power is over 90% full
1. Tap Settings> Honeywell Settings>Battery LED
2. Select from the following options:
a. Default Battery LED
b. Honeywell Battery LED (Factory default settings)
c. No Battery LED