Sensepoint XCD RFD Technical Manual SPXCDHMRFEN Issue 4_08-2016
57
1/1
BEN
PPS R-4 230BL
05/Nov/08
A
1
14.00
2
6
.
6
5
°
1
.
0
0
1
.
6
0
4
8
.
0
0
75.0
1
38
.
8
10.0
2.3
22.2
88.00
2
.
3
0
2.3
6.30
NOTES
1. General draft angle 1° unless otherwise stated
2. Internal Radii: 0.2 Max unless otherwise stated
3. Component Volume: 4.68 cm^3
4. The position of feed points, split lines and
ejectors to be agreed by HAAP before tool
production commences (Max permissable flash
0.02)
5. PTFE, SILICONE or STEARAE RELEASE
AGENTS must not be used during manufacture.
6. The CAD DATA to be used as the master
information for producing this component.
Dimensions on this drawing are for reference only.
7. All surfaces to be free from sink marks,
machining marks, scratches and other blemishes.
5.00
6
1
.
1
Ø
17.4 Collecting Cone Drawing
To Next Page
Loading...
