Honeywell Silent knight 5895XL - Board and Terminal Description

10 5895XL Manual — P/N 151142-L8:M 2/15/2022
Section 2: Before You Begin Installing
2.1 Inventory
The 5895XL ships with the following hardware:
• A cabinet with all hardware assembled
• Two keys for the front door
• Ten 4.7K ohm end-of-line resistors
• A battery cable for batteries wired in series
2.2 Environmental Specifications
It is important to protect the 5895XL control panel from water. To prevent water damage, the following conditions should be observed when
installing the units:
• Do not mount directly on exterior walls, especially masonry walls (condensation).
• Do not mount directly on exterior walls below grade (condensation).
• Protect from plumbing leaks.
• Protect from splash caused by sprinkler system inspection ports.
• Do not mount in areas with humidity-generating equipment (such as dryers, production machinery).
When selecting a location to mount the 5895XL, the unit should be mounted where it will NOT be exposed to temperatures outside the range
of 0°C-49°C (32°F-120°F) or humidity outside the range of 10%-93% at 30°C (86°F) non-condensing.
2.3 5895XL Board and Terminal Strip Description
Figure 2.1 shows the 5895XL circuit board including location of terminals, the DIP switch for setting module ID, and the LED.
NOTE: For UL installations, 4.7kΩ end-of-line resistor (ordered separately) must be used.
33
-
MAIN SBUS IN OUT /
32 31 30
+AB
29 2628 2527 24
N.O. N.O.CCN.C. N.C.
RELAY 1 RELAY 2
23 1922 1821 1720 16
--++AABB
SBUS IN
SBUS OUT
151413121110987654
O
O
X
X
OXOXOXOX
I/O 1 I/O 2 I/O 3 I/O 4 I/O 5 I/O 6
NL
321
G
ON
12345
6
DIP switches
for setting ID
LED
for connection
to FACP or to
controlling
5895XL if daisy-
chained
conventional
relay circuits
SBUS module
connections
regulated Flexput circuits
Figure 2.1 5895XL Board Layout
AC Power