Honeywell UDC1200 MICRO-PRO - Page 5

UDC 1200 Start-Up Guide Rev 1
Parameter
Lower
Display
Upper
Display
Adjustment range
Default
Retransmit Output 1
Scale maximum

-1999 to 9999 (display value at which output
will be maximum)
Range
max
Retransmit Output 1
Scale minimum

-1999 to 9999 (display value at which output will
be minimum)
Range
min
Output 2 Usage

As for output 1
Sec or
Al2
Lin. O/P 2 Range


Retransmit Output 2
Scale maximum

-1999 to 9999 (display value at which output
will be maximum)
Range
max
Retransmit Output 2
Scale minimum

-1999 to 9999 (display value at which output will
be minimum)
Range
min
Output 3 Usage

As for output 1

Linear Output 3
Range


Retransmit Output 3
Scale maximum

-1999 to 9999 (display value at which output
will be maximum)
Range
max
Retransmit Output 3
Scale minimum

-1999 to 9999 (display value at which output will
be minimum)
Range
min
Display Strategy

, , , ,  or  (refer to section 7)

Comms Protocol


ASCII
Mm
Mm
Modbus with no parity
Mm
Modbus with Even Parity
Mm
Modbus with Odd Parity
Bit rate

.
1.2 kbps
.
.
2.4 kbps
.
4.8 kbps
.
9.6 kbps
.
19.2 kbps
Comms Address


1 –255 (Modbus), 1-99 (ASCII)

Comms Write

Read only or read/write
r_ Ww
Digital Input Usage


Setpoint 1 / Setpoint 2 select


Automatic / Manual select
Config Lock Code

0 to 9999

* Refer to the full user guide for further details on these parameters.