Rev 1.0 28 Document 900.0840
09/06
Simple Alarm Sequence Configuration
5. Click on the arrow in the command field. A drop down box appears.
6. A selection of the available commands appears. Scroll down and select "OUTPUT".
Note Help information is displayed for each command and its associated
parameters at the bottom of the screen
7. Enter the Output in the Parm (parameter) #1 column
8. Enter the Output State = 1 in the Parm #2 column. State 1 - is On; State 0 - is Off
9. Click on Download to send configuration to the CPU.
Programming Sequence #2
From the Configuration Program, click on the Sequence tab
1. Perform steps 1-7 of Programming Sequence #1.
2. Enter the Output in the Parm (parameter) #1 column
3. Enter the Output State = 0 in the Parm #2 column; State 1 - is On; State 0 - is Off
4. Click on Download to send configuration to the CPU.
To Next Page
Loading...
Need help?
General
