VISIONPRO
®
8000 WITH WI-FI
®
33-00096—01 82
Fig. 218.
Pre-Occupancy Purge
The thermostat can be set up for Pre-Occupancy Purge in the
installer setup (ISU 401). When setup for Pre-Occupancy
Purge, the thermostat runs the fan 1 to 3 hours before each
occupied period to provide a comfortable workplace upon
arrival. Options are Off and 1 to 3 hours.
Fig. 219.
WIRED INDOOR SENSORS
For wiring, see “Wiring guide — Wired Indoor Sensors” on
page 88.
Indoor Sensor Operation
Temperature Control
The thermostat can be set to respond to its internal
temperature sensor, or to an optional wired indoor sensor. If
multiple sensors are used, the thermostat will average the
temperature detected at each sensor.
In Fig. 220, both the thermostat internal sensor and wired
indoor sensor are being used for Temperature Control and are
being averaged since both sensors are set to “Yes.” Select “No”
if you do NOT want a specific sensor to be used for
temperature control or be part of the temperature average.
Fig. 220.
Temperature Display
The temperature reading displayed on the home screen is from
the sensor or sensors that are being used for temperature
control.
In Fig. 221, the temperature reading is the average of the
thermostat internal sensor and the indoor sensor.
Fig. 221.
To Next Page
Loading...
