VISIONPRO
®
8000 WITH WI-FI
®
9 33-00096—01
Fig. 13. Thermostat wired directly to equipment.
1. Power the thermostat using Rc and C terminals. Refer to
Fig. 14.
Fig. 14. Inserting wires in thermostat terminal block.
Mounting Thermostat on Wallplate
1. Align thermostat at bottom and snap into place as
shown.
Fig. 15. Mount thermostat.
Finding Your Password (Date Code)
to Access Installer Options
You need a password (Date Code) to access Installer Options.
Installer Options allow you to:
• Make changes to the Installer Setup.
• Perform an Installer Test.
• Reset the thermostat to Factory Default settings.
The password (Date Code) is located on the back of the
thermostat. It can also be found by following these steps:
1. Touch Menu.
2. Select Dealer Information.
Fig. 16.
3. Scroll down to see the Date Code.
Fig. 17.
S1
S1
W
Y
G
W2
Y2
A
S1
S1
O/B
Y
G
AUX
-E
Y2
L/A
K
RC
R
U1
U1
U2
U2
C
CONVENTIONAL
HEAT PUMP
S1
S1
W
Y
G
W2
Y2
A
S1
S1
O/B
Y
G
AUX
-E
Y2
L/A
K
RC
R
U1
U1
U2
U2
C
CONVENTIONAL
HEAT PUMP
MCR34022
Dealer Information
Installer Options
MCR35348
TH8321WF1001
Date Code: 1524
To Next Page
Loading...
