Honeywell VISTA Series - Verification Modes Overview

HoneywellVISTASeriesProductsUserManual
9
New Enroll
CARD:16650449
UserID:  00010
ESC(N) OK(Save)
Note:Thelast digit"C"
in "00010C" denotes
IDcard.
6)PressOKtosavetheenrolleddataandcompletetheIDcardenrollment.
Note:
The IDcardverificationisanoptionalfunction.To customize anIDcardcapableFRT, pleaseconsult our
commercialrepresentativesorpresaletechnicalsupportengineers.
3.2CheckEnrollmentEffect
Afterenrollingafingerprint,youneedtoverifyitsvaliditybyplacingyourcorrespondingfingerproperlyonthe
initialinterfaceoftheFRT.IftheFRTrecognizesyourfingerprintsuccessfully,itprovesthatyourfingerprintis
clear and recognizable; otherwise, you need to reenroll your fingerprint or change another finger for
enrollment.Ifitstilldoesnotwork,itprovesthatyourfingerprintsarenotsuitableforrecognitionandyouneed
toadoptthefingerprintandpasswordverificati onmode.
3.3VerificationModes
3.3.1FingerprintVerification
Youcanadopt1:1and1:Nmatchingmodesf orfingerprintidentification.
(1)1:1fingerprintmatching(ID+fingerprint)
In the 1:1 fingerprint matching mode, the FRT compares the current fingerprint collected t hrough the
fingerprintreaderwiththatinrelationtotheuserIDenteredthroughkeyboard.
Operationsteps:
EnterauserIDthroughkeyboardontheinitialinterface.
1:1FPMatch
PIN:00011
ESC(Exit) OK(Y)
Note:TheFRTdisplays5digitnumbers,andautomaticallyadds0asprefixtothenumberslessthan5digits.
Forexample,ifyouinput"11",theFRTwilldisplay"00011".
PressOKandthenplaceyourfingeronthefingerprintreader,ordirectlyplaceyour fingeronthefingerprint
readertodisplaythefollowinginterface:
1:1FPMatch
RemoveFinger
Iftheverificationsucceeds,followinginterfacewillbedisplayed: