Honeywell Voyager 1452g Series - Page 167

10 - 13
Clear One Prefix PRECL2 5-2
Clear All Prefixes PRECA2 5-2
Suffix Add Suffix SUFBK2## 5-2
Clear One Suffix SUFCL2 5-2
Clear All Suffixes SUFCA2 5-2
Function Code Transmit *Enable RMVFNC0 5-3
Disable RMVFNC1 5-3
Intercharacter Delay Range 0 - 1000 (5ms increments) DLYCHR## 5-3
User Specified
Intercharacter Delay
Delay Length
0 - 1000 (5ms increments)
DLYCRX## 5-4
Character to Trigger Delay DLY_XX## 5-4
Interfunction Delay Range 0 - 1000 (5ms increments) DLYFNC## 5-4
Intermessage Delay Range 0 - 1000 (5ms increments) DLYMSG## 5-4
Data Formatter Selections
Data Format Editor *Default Data Format (None) DFMDF3 6-1
Enter Data Format DFMBK3## 6-2
Clear One Data Format DFMCL3 6-2
Clear All Data Formats DFMCA3 6-2
Data Formatter Data Formatter Off DFM_EN0 6-9
*Data Formatter On,
Not Required,
Keep Prefix/Suffix
DFM_EN1 6-9
Data Format Required,
Keep Prefix/Suffix
DFM_EN2 6-9
Primary/Alternate Data Formats Primary Data Format ALTFNM0 6-9
Data Format 1 ALTFNM1 6-9
Data Format 2 ALTFNM2 6-9
Data Format 3 ALTFNM3 6-10
Symbologies
All Symbologies All Symbologies Off ALLENA0 7-1
All Symbologies On ALLENA1 7-1
Codabar Default All Codabar
Settings
CBRDFT 7-2
Off CBRENA0 7-2
*On CBRENA1 7-2
Codabar Start/Stop Char. *Don’t Transmit CBRSSX0 7-2
Transmit CBRSSX1 7-2
Codabar Check Char. *No Check Char. CBRCK20 7-2
Validate, But Don’t Transmit CBRCK21 7-3
Validate, and Transmit CBRCK22 7-3
Codabar Concatenation *Off CBRCCT0 7-3
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page