3 - 20
Default = Batch Mode Off.
Batch Mode Beep
When scanning in Inventory Batch Mode (page 3-20), the scanner beeps
every time a bar code is scanned. If using a Granit scanner, it also
vibrates. When Batch Mode Beep is On, you will also hear a click when
each bar code is sent to the host. If you do not want to hear these clicks,
scan Batch Mode Beep Off.
Default = Batch Mode Beep On.
Batch Mode Storage
When a scanner is storing data during a Batch Mode process, you can
select whether the data is stored in Flash memory or in RAM.
Flash Storage: The scanner writes any untransmitted data to flash mem-
ory prior to powering down. The data will still be there when the scanner
powers back up. However, the scanner will power down, even with untrans-
mitted data, if it reaches a power down timeout or if the battery power is
very low.
Automatic Batch Mode
* Batch Mode Off
Inventory Batch Mode
Persistent Batch Mode
* Batch Mode Beep On
Batch Mode Beep Off
To Next Page
Loading...
