Honeywell XENON 1902

ii
Datalogic™ Magellan
®
Aux Port Configuration ...........2-7
NCR Bioptic Aux Port Configuration............................2-8
Wincor Nixdorf Terminal Default Settings....................2-8
Wincor Nixdorf Beetle™ Terminal Default Settings.....2-8
Keyboard Country Layout............................................2-9
Keyboard Style ..........................................................2-19
Keyboard Conversion ................................................2-21
Control Character Output...........................................2-21
Keyboard Modifiers....................................................2-22
RS232 Modifiers ........................................................2-23
RS232 Baud Rate................................................2-23
RS232 Word Length: Data Bits, Stop Bits,
and Parity .......................................................2-25
RS232 Receiver Time-Out...................................2-26
RS232 Handshaking............................................2-27
RS232 Timeout....................................................2-28
XON/XOFF ..........................................................2-28
ACK/NAK .............................................................2-28
Scanner to Bioptic Communication............................2-29
Scanner-Bioptic Packet Mode .............................2-29
Scanner-Bioptic ACK/NAK Mode.........................2-30
Scanner-Bioptic ACK/NAK Timeout.....................2-30
Chapter 3 - Cordless System Operation
How the Cordless Charge Base/
Access Point Works ..................................................3-1
Linking the Scanner to a Charge Base........................3-1
Linking the Scanner to an Access Point ......................3-2
Communication Between the Cordless System
and the Host..............................................................3-2
Programming the Scanner and Base or Access
Point ..........................................................................3-3
RF (Radio Frequency) Module Operation....................3-3
System Conditions.......................................................3-4
Linking Process .....................................................3-4
Scanner Is Out of Range .......................................3-4