Honeywell XENON 1902

11 - 13
RS232 Handshaking *RTS/CTS Off 232CTS0 2-27
Flow Control, No
Timeout
232CTS1 2-27
Two-Direction Flow
Control
232CTS2 2-27
Flow Control with
Timeout
232CTS3 2-27
RS232 Timeout 232DEL#### 2-28
*XON/XOFF Off 232XON0 2-28
XON/XOFF On 232XON1 2-28
*ACK/NAK Off 232ACK0 2-29
ACK/NAK On 232ACK1 2-29
Scanner-Bioptic
Packet Mode
*Packet Mode Off 232PKT0 2-29
Packet Mode On 232PKT2 2-3
Scanner-Bioptic
ACK/NAK Mode
*Bioptic ACK/NAK
Off
232NAK0 2-30
Bioptic ACK/NAK
On
232NAK1 2-30
Scanner-Bioptic
ACK/NAK Timeout
ACK/NAK Timeout
*5100
232DLK##### 2-30
Cordless System Operation
Note: This section applies only to cordless systems. It does not apply to
corded scanners.
Base Power
Communication
Indicator
*On :*:BASRED1 3-9
Off :*:BASRED0 3-9
Reset Scanner Reset Scanner RESET_ 3-9
Scanning While in
Base Cradle
Scanning in Cradle
Off
BT_SIC0 3-10
*Scanning in Cradle
On (CCB01-010BT
default)
BT_SIC1 3-10
Shut Down Scanner
in Cradle
BT_SIC2 3-10
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page