Honeywell XENON 1902

11 - 25
Single Scan Data
Format Change
Single Scan-Primary
Data Format
VSAF_0 6-19
Single Scan-Data
Format 1
VSAF_1 6-19
Single Scan-Data
Format 2
VSAF_2 6-19
Single Scan-Data
Format 3
VSAF_3 6-19
Symbologies
All Symbologies All Symbologies Off ALLENA0 7-2
All Symbologies On ALLENA1 7-2
Codabar Default All Codabar
Settings
CBRDFT 7-3
Off CBRENA0 7-3
*On CBRENA1 7-3
Codabar Start/Stop
Char.
*Don’t Transmit CBRSSX0 7-3
Transmit CBRSSX1 7-3
Codabar Check
Char.
*No Check Char. CBRCK20 7-4
Validate, But Don’t
Tra nsm it
CBRCK21 7-4
Validate, and
Tra nsm it
CBRCK22 7-4
Codabar
Concatenation
*Off CBRCCT0 7-4
On CBRCCT1 7-4
Require CBRCCT2 7-4
Codabar Message
Length
Minimum (2 - 60) *4 CBRMIN## 7-5
Maximum (2 - 60)
*60
CBRMAX## 7-5
Code 39 Default All Code 39
Settings
C39DFT 7-6
Off C39ENA0 7-6
*On C39ENA1 7-6
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page