1 - 3
2. If you are connecting a Granit scanner, make sure the cable is pushed
tightly into the scanner. Loosen the locking plate and slide it over the
base of the cable connector to lock the cable in place. Tighten the
screw.
Note: The power supply must be ordered separately, if needed.
3. If you are connecting a CCB01-010BT Base, make sure the cables are
secured in the wireways in the bottom of the cordless base and the
CCB01-010BT Base
USB Connection:
CCB02-100BT Base
USB Connection:
To Next Page
Loading...
