Honeywell XENON 1902G-BF - Low Power Alert Beep; Base; Base Communication and Scanning

86 Xenon/Granit User Guide
Interval Between Alerts
If you have set the Low Power Alert Repeat (page 85) to more than 1, you can set
the length of time, in seconds, between the low power alerts. To set this interval,
scan the bar code below and then scan a digit (10-120) bar code from the
Programming Chart, beginning on page 341, then Save. Default = 10 seconds
between alerts.
Low Power Alert Beep
If you do not want the beeper to sound for a low power alert, scan the Low Power
Alert Beep Off bar code. Any low power alert settings will still flash the scanner
LEDs, whether or not the beeper sounds. Default = Low Power Alert Beep On.
Base
The base contains colored LEDs that indicate the status of the unit, verifies its
communication with the host system, and indicates scanner instant charge pack
condition.
Base Communication and Scanning
The following feedback is provided by the base and indicates communication and
scanning status.
Interval Between Alerts
Low Power Alert Beep Off
*Low Power Alert Beep On
Red LED - Host Communication
Red LED
Communication
Condition
Off USB suspend
On continuously Host communication
available