Xenon/Granit User Guide 115
Beeper Duration – Good Read
The beeper duration codes modify the length of the beep the scanner emits on a
good read. Default = Normal.
LED – Good Read
The LED indicator can be programmed On or Off in response to a good read.
Default = On.
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same
number of beeps will be applied to the beeper and LED in response to a good read.
For example, if you program this option to have five beeps, there will be five beeps
and five LED flashes in response to a good read. The beeps and LED flashes are in
sync with one another. To change the number of beeps, scan the bar code below
and then scan a digit (1-9) bar code from the Programming Chart, beginning on
page 341, then Save. Default = 1.
Number of Beeps – Error
The number of beeps and LED flashes emitted by the scanner for a bad read or
error can be programmed from 1 - 9. For example, if you program this option to
have five error beeps, there will be five error beeps and five LED flashes in response
Number of Good Read Beeps/LED Flashes
To Next Page
Loading...
