Honeywell XENON 1902G-BF - User Specified Intercharacter Delay; Interfunction Delay

Xenon/Granit User Guide 155
To remove this delay, scan the Intercharacter Delay bar code, then set the number
of delays to 0. Scan the Save bar code from the Programming Chart, beginning on
page 341.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length bar code below, then scan the number of 5ms delays from the
Programming Chart, beginning on page 341, then Save.
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value for a
printable character to trigger the delay (see Lower ASCII Reference Table,page
331.
)
To remove this delay, scan the Delay Length bar code, and set the number of delays
to 0. Scan the Save bar code from the Programming Chart, beginning on page 341.
Interfunction Delay
An interfunction delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each control character in the message string.
Scan the Interfunction Delay bar code below, then scan the number of 5ms
delays, and the Save bar code from the Programming Chart, beginning on page
341.
Delay Length
Character to Trigger Delay
Interfunction Delays
Prefix Scanned Data Suffix
1 2345STX HT CR LF
Interfunction Delay