XI581/2 BUSWIDE OPERATOR INTERFACE GETTING STARTED
9 EN2B-0126 (74-3554-8)
Display Area Description
Fig. 11. MMI display area.
Display Window
The XI581/2 display window is located above the keypad. The window presents
system information, operator entries, and menus of functions that you can perform.
Menu Example For example, the following is the first menu (the Main Menu) that appears. It shows
the controller name, the current time and date, and a list of functions you can select.
The word Password is highlighted (reverse video on the display) because it is the
default selection.
CONTROLLER_07 18:16!
Running 15.12.1994
Password Alarms
Time Programmes Trend Buffer
Data Points System Clock
System Data
The buswide alarm flag (exclamation mark, !, in the top right-hand corner of the
window) indicates that the buswide alarm notification mode is enabled. If it is
blinking, an alarm has occurred. The "Alarm Information" section describes alarm
display and acknowledgment.
Time Program Window Example The following window display appears when you select 'Time Programmes'. It lists
the zones that have time programs and waits for operator selection of a zone. The
scroll bar is on the right-hand side of the window.
Time Programme
Time Program 1 ▲
▲▲
▲
Ventil. Sys ■
Lighting 1
Heating zone east ■
Heating zone west ▼
To Next Page
Loading...
