To Next PageTo Next Page
Need help?Do you have a question about the Hoover Dimension and is the answer not in the manual?
General| Brand | Hoover |
|---|---|
| Model | Dimension |
| Category | Vacuum Cleaner |
| Language | English |
Procedure for removing the outer bag from Legacy and Legacy II models.
Steps to remove the bag housing and its associated components.
Accessing and understanding the Dirt Finder system's electronic components.
Procedure for removing the main power switch.
Steps for safely removing and handling the electronic circuit board.
Instructions for removing the microphone component.
Steps to remove the bracket that holds the bag housing.
Removing the jacket support cap on models with an air freshener dispenser.
Removing the upper jacket support on models without an air freshener dispenser.
Procedure for removing the lower jacket support.
Steps for removing the tool rack and its associated hose.
Disassembly of the handle assembly and attachment cord.
Steps for servicing or replacing the upper handle assembly and bag strap.
Procedure for removing the hood and its components, including the air intake door.
Instructions for removing and replacing the vacuum cleaner headlight bulb.
Steps for removing the bottom plate of the cleaner.
Procedure for removing the agitator and its drive belt.
Steps to remove the front wheel assembly and associated lever.
Procedure for removing the valve gate component.
Steps to remove the nozzle height adjustment mechanism.
Procedure for removing the rear wheel shaft and wheels.
Steps to remove the lever that controls handle adjustment.
Procedure for removing the main motor assembly.
Procedure for replacing the motor brush holder assembly.
Instructions for removing and replacing the cleaner's on/off switch.
Diagnosing and resolving issues where the motor fails to start.
Troubleshooting causes for the motor running but the cleaner not picking up dirt.
Identifying and fixing intermittent motor operation problems.
Diagnosing and resolving issues causing the motor to overheat.
Troubleshooting causes for unusual noise from the cleaner.
Diagnosing why the cleaner has no pickup when using attachments.
Troubleshooting why the Dirt Finder circuit board does not illuminate.
Diagnosing why the Dirt Finder light fails to indicate cleaning status correctly.
Common causes and solutions for the vacuum motor failing to run.
Resolving issues where the motor runs but pickup performance is poor.
Diagnosing and fixing problems with the motor running intermittently.
Addressing issues where the motor is running excessively hot.
Identifying and resolving sources of unusual noise from the cleaner.
Troubleshooting why attachments fail to provide adequate suction.
Diagnosing and fixing instances of dirt or dust leaking from the cleaner.
Resolving issues related to the frequent breaking of drive belts.
Fixing problems with the nozzle not aligning or raising correctly when the handle is upright.
