9 Shutdown and Disposal
Linear actuators MC250 • MC253 • MC500 • MC503
Operating Manual Version 2.1 - March 2011 31
Equipment damage due to defective spare parts!
Spare parts must comply with the technical requirements specified by the
manufacturer.
• Use only original spare parts.
2.1 Components on page 6
2.2 Accessories on page 7
9 Shutdown and Disposal
Dispose of the linear actuator in accordance with national regulations and
legislation.
10 Troubleshooting
The path-measuring system needs to be re-initialised after troubleshooting.
5.9 Initialise the path-measuring system on page 27
10.1 Troubleshooting
If the linear actuator does not work perfectly, proceed as follows to eliminate the
fault:
1 Check that the linear actuator was installed correctly.
2 Check the linear actuator settings and the rating plate data.
3 Eliminate the faults using the checklist.
10.2 Operating faults checklist on page 32
4 If this fault still cannot be eliminated, contact the manufacturer.
5 Please quote the following for all queries and returning goods to the
manufacturer:
• F-No. (Fabrication No. = Contract No.)
• Type designation
• Power supply and frequency
• Additional equipment
• Error report
6 If the fault cannot be eliminated by the inquiry, the equipment can be returned to
the manufacturer.
To Next Page
Loading...
Need help?
General
