5 Commissioning
Linear actuators MC250 • MC253 • MC500 • MC503
28 Version 2.1 - March 2011 Operating Manual
5.10 Commissioning
1 Check that all installation and assembly tasks have been completed correctly.
4 Assembly on page 12
2 Ensure that the electric actuation of the linear actuator is ensured without danger
to persons or equipment or the system.
3 Ensure that the linear actuator is correctly fixed and the linear actuator cover is
closed.
4.4 Fit/remove cover on page 14
4 Ensure that the linear actuator is switched to Automatic mode.
6.1 Switching between Manual and Automatic modes on page 29
5 Ensure that the operating parameters have been correctly set.
5.1 Operating parameters and coding switch positions on page 22
6 Ensure that the path-measuring system has been initialised.
5.9 Initialise the path-measuring system on page 27
7 Connect the power supply. Then the linear actuator moves to the reference
point.
The linear actuator is ready for operation.
To Next Page
Loading...
Need help?
General
