STOP
STOP
command
The STOP command is a run control command that stops the logic
analyzer. The STOP command is on the same level in the command tree
as SYSTem; therefore, it is not preceded by :SYSTem.
p’
The STOP command is an Overlapped Command. An Overlapped
Note
@
c
ommand is a command that allows execution of subsequent commands
while the device operations initiated by the Overlapped Command are still
in progress.
Command Syntax:
STOP
Example:
OUTPUT XX&%TOp”
HP 1650B/HP 16518
Programming Reference
System Commands
637
To Next Page
Loading...
