STARt
STARt
Note
4
command
The STARt command is a run control command that starts the logic
analyzer running in the
specihed
run mode (see
RMODe).
The STARt
command is on the same level in the command tree as SYSTem; therefore,
it is not preceded by :SYSTem.
The STARt command is an Overlapped Command. An Overlapped
Command is a command that allows execution of subsequent commands
while the device operations initiated by the Overlapped Command are
still
in progress.
Command Syntax:
Example:
System Commands
6-36
STAR1
OUTPUT XXX;":START"
HP 1650B/HP 16518
Programming Reference
To Next Page
Loading...
