HP 1650B

LOAD
LOAD
Note f!b
Command Syntax: :MMEMory:LOAD[:CONfig] <name>
where:
c name > :: = string of up to 10 alphanumeric characters representing a valid file name
Examples:
HP 1650B/HP 1651B
Programming Reference
[:CONFig] command
The LOAD command loads a file from the diik into the analyzer. The
[:CONfig] specifier is optional and has no effect on the command. The
-C name > parameter specifies the filename that will be loaded into the
logic analyzer.
Any previous setups and data in the instrument are replaced by the
contents of the confiiation file.
OUTPUT XXX;“:MMEMORY:LOAD:CONFIG ‘FILE-“’
OUTPUT XXX;“:MMEMORY:LOAD ‘FILE-“’
OUTPUT XXX;“:MMEM:LOAD:CONFIG ‘FILE-A”’
MMEMory Subsystem
7-9