HP 1650B - Wlist

WLlSt
WLlSt selector
The WLISt (Waveforms/listing) selector is used as a part of a compound
header to access the settings normally found in the Mixed Mode menu.
Since the WLISt command is a root level command, it will always appear
as the first element of a compound header.
Note d
Command Syntax:
Example:
WLlSt Subsystem
9-2
The WLISt Subsystem is only available when one state analyzer (with time
tagging on) and one timing analyzer are specified.
:WLISt
OUTPUT XXX;": WLIST:XTIME 40.OE-6"
HP 1650B/HP 16518
Programming Reference