HP 1650B

“SRE
“SRE
Note d
Command Syntax: l SRE c mask >
where:
c mask >
Example: OUTPUT XXX ; “*SRE 16”
HP 1650B/HP 16518
Programming Reference
(Service Request Enable) command/query
The *SRE command sets the Service Request Enable Register bits. The
Service Request Enable Register contains a mask value for the bits to be
enabled in the Status Byte Register. A one in the Service Request Enable
Register will enable the corresponding bit in the Status Byte Register. A
zero will disable the bit. Refer to table 5-3 for the bits in the Service
Request Enable Register and what they mask.
The *SRE query returns the current value.
Refer to Appendix B for a complete discussion of status.
:: = integer from 0 to 255
This example forces the MSS bit high (see table 5-3).
Common Commands
5-11