RMODe
RMODe
command/query
The RMODe command is a run control command that specifies the run
mode for logic analyzer. It is at the same level in the command tree as
SYSTem; therefore, it is not preceded by :SYSTem.
The query returns the current setting.
#’
After specifying the run mode, use the
STARt
command to start the
Note
d
acquisition.
Command Syntax:
:RMODe
{
SlNGle
1
REPetitivs}
Example:
OUTPUT XXX
;
”
:RMOOE SINGLE”
Query Syntax:
:R~ow
Returned Format:
[:RMDDe]
{SINGle
1
REPetitive}
c
NL>
Example:
10 DIM
Mode$[lOOl
20 OUTPUT
XXX;“:RMOOE?”
30 ENTER
XXX;Mode$
40 PRINT
Mode$
50 END
HP 1650B/HP 16518
Programming Reference
System Commands
6-33
To Next Page
Loading...
