LOAD
LOAD
:IASSem bler
command
This variation of the LOAD command allows inverse assembler files to be
loaded into analyzer 1 or analyzer 2 of the HP
1650B/51B.
The
c
L4
name
>
parameter specifies the inverse assembler filename. The
parameter
after the
-z
IA-name
>
parameter specifies into which
machine the inverse assembler is loaded.
l
’
Note
@
Inverse assembler files should only be loaded into the state analyzer. If an
inverse assembler file is loaded into the timing analyzer no error will be
generated; however, it will not be accessible.
Command Syntax:
:MMEMory:LOAD:lASSembler
CIA-name
>
,{
112)
where:
c
IA-name
>
:: = string of up to 10 alphanumeric characters representing a valid file name
Examples:
OUTPUT XXX;“:MMEMORY:LOAD:IASSEMBLER
‘16BO2O~IP’,l”
OUTPUT
XXX;“:MMEM:LOAD:IASS
‘16802O~IP’l”
MMEMory Subsystem
7-10
HP
1650B/HP
1651B
Programming Reference
To Next Page
Loading...
