HP 1650B User Manual

MACHine Subsystem 10
Introduction The MACHine subsystem contains the commands available for the
State/Timing Configuration menu. These commands are:
l ARM
l ASSign
l AUToscale (Timing Analyzer only)
l NAME
l TYPE
There are actually two MACHine subsystems: MACHinel and
MACHine2. Unless noted, they are identical. In the syntax definitions
you will see MACHine{ 112) anytime the subject is applicable to both
subsystems.
Additionally, the following subsystems are a part of the MACHine
subsystem. Each is explained in a separate chapter.
HP 1650B/HP 16518
Programming Reference
l SFORmat subsystem
l STRace subsystem
l SLISt subsystem
l SWAVeform subsystem
l SCHart subsystem
l
COMPare subsystem
l TFORmat subsystem
l
‘ITRace subsystem
l
TWAVeform subsystem
l
SYMBol subsystem
(chapter 11)
(chapter 12)
(chapter 13)
(chapter 14)
(chapter 15)
(chapter 16)
(chapter 17)
(chapter 18)
(chapter 19)
(chapter 20)
MACHine Subsystem
10-l

HP 1650B Specifications

General

Brand	HP
Model	1650B
Category	Measuring Instruments
Language	English