HP 1650B

RESTart
RESTart command/query
The RESTart command selects the type of restart to be enabled during
the trace sequence. It also defines the global restart qualifier that restarts
the sequence in global restart mode. The qualifier may be a single term or
a complex expression. The terms A through H are defmed by the TERM
command. The meaning of INRange and OUTRange is determined by
the RANGe command.
Expressions are limited to what you could manually enter through the
Format menu. Regarding parentheses, the syntax definitions below show
only the required ones. Additional parentheses are allowed as long as the
meaning of the expression is not changed.
A detailed example is provided in figure 12-2.
The RESTart query returns the current restart specification.
Command Syntax: :MACHine{ 1 j2):STRace:RESTart {OFF ) PERLevel 1 -z restart_qualifier z= }
where:
c restart-qualifier > :: = { ANYState 1 NOSTate 1 c any-term > 1
c any-term >
6 expression 1 >
< expression2 z=
<or term1 >
c and-term 1 >
car term2>
c and term2 >
( e expression 1 > [{AND I OR} c expression2 > ]) I
(cexpression2> [{ANDIOR} <expression1 >I) }
:: = { c or-term1 > I <and-term1 > I < or-term2 > I c and-term2 > }
:: = { <or-term1 > [OR <or-term1 >I... I cand-term1 > [AND <and-term1 >I...}
:: = { cor_term2> [OR cor_term2>]... I cand_term2> [AND <and_term2>]...)
::= {A~B~C~D(INRangelOUTRange}
:: = { NOTA I NOTB I NOTC I NOTD I INRange I OUTRange}
::= {EIFIGIH)
::= {NOTEINOTFINOTGjNOTH}
Examples: OUTPUT XXX;":MACHINEl:STRACE:RESTART OFF"
OUTPUT XXX;" :MACHINEl:STRACE:RESTART PERLEVEL"
OUTPUT XXX;“:MACHINEl:STRACE:RESTART (NOTA AN0 NOTE AND INRANGE)”
OUTPUT XXX;“:MACHINEl:STRACE:RESTART (B OR (NOTE AND NOTF))”
STRace Subsystem
12-14
HP 1650B/HP 16518
Programming Reference